· DCS Planner

Glossary

Hold in DCS

A hold is time spent on a point before flying the next leg. It is either a duration, such as an orbit or a CAP, or a wait until a departure time that absorbs arriving early, which makes the point a push point. In DCS Planner it belongs to the leg leaving the point.

Also called: Holding, Push point, Orbit.

The hold can sit anywhere on that leg: on the point after its time, along the leg, or on the next point before its time, which then becomes the push. Its place does not change the timing. Two holds never share a leg.

Before a gap in the route, the hold gives the time spent off route. Without it, the timing stops at the gap.

In DCS Planner

The interface labels are "Hold", "For" for a duration, "Until" for a push time, and "Off route".

What it is not

Is a hold the same as a TOT?
No. A hold is time spent on a point. A TOT is the clock time the flight should reach a point.

Related terms

Read more

Open the planner